LG Gas Dryer Manual Repair

The LG Gas Dryer is a high-efficiency laundry appliance featuring multiple drying cycles, temperature settings, moisture sensors, and safety features. This manual covers installation, operation, maintenance, troubleshooting, and repair procedures for common issues. Below are key sections for safety, features, installation, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Installation 3. Operation 4. Specifications 5. Controls and Settings 6. Maintenance 7. Common Repairs 8. Safety Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Stainless steel drum, electronic controls, moisture sensors, lint filter, gas burner assembly, exhaust system.

Feature	Description
Drying Cycles	Normal, Delicates, Heavy Duty, Timed Dry, Air Fluff
Temperature Settings	High, Medium, Low, No Heat
Moisture Sensor	Automatically detects dryness level
Lint Filter	Removable for easy cleaning
Door Switch	Safety switch stops operation when door opens
Thermal Fuse	Overheat protection device
Gas Valve	Controls gas flow to burner
Igniter	Electronic ignition system
Motor	Drives drum rotation and blower
Control Board	Electronic control system

Installation

Unpack and inspect contents. Ensure proper gas and electrical connections.

Location: Place on level surface with adequate ventilation.
Gas Connection: Use approved gas line and fittings; check for leaks with soap solution.
Ventilation: Install 4-inch diameter metal exhaust duct; avoid sharp bends.
Electrical: Connect to properly grounded 120V outlet.
Leveling: Adjust leveling feet for stable operation.

WARNING! Gas appliances require professional installation. Ensure all connections are secure and leak-free.

Operation

Power on dryer; select desired cycle and settings.

Load laundry: Do not overload; leave space for tumbling.
Select cycle: Choose appropriate cycle for fabric type.
Set temperature: Select heat level based on fabric care labels.
Start: Close door and press START button.
Monitor: Check lint filter regularly during use.

CAUTION! Do not dry items containing foam, rubber, or plastic. Clean lint filter after every use.

Specifications

Capacity: 7.4 cubic feet
Energy Source: Natural Gas or LP Gas
Voltage: 120V AC, 60Hz
Ignition: Electronic ignition
Controls: Electronic touch controls
Drum Material: Stainless steel
Exhaust: 4-inch diameter
Dimensions: 27" W x 29" D x 43" H
Weight: 125 lbs

Controls and Settings

Access settings via control panel. Power: ON/OFF button. Cycle Selection: Normal, Delicates, Heavy Duty, Timed Dry, Air Fluff. Temperature: High, Medium, Low, No Heat. Options: Wrinkle Prevent, Signal, Delay Start.

Display: Shows remaining time, cycle status, error codes. Settings: Can be adjusted during cycle if allowed.

Maintenance: Filter clean indicator, diagnostic mode access. Child Lock: Prevents accidental changes to settings.

Maintenance

Regular maintenance ensures optimal performance and safety.

Lint Filter: Clean after every load; wash monthly with warm water.
Exhaust System: Inspect and clean vent duct annually.
Drum: Wipe clean with damp cloth; avoid abrasives.
Exterior: Clean with mild detergent and soft cloth.
Gas Connections: Check annually for leaks.

Tip: Keep area around dryer clear of lint and combustible materials.

Common Repairs

Common issues and repair procedures for DIY maintenance.

No Heat: Check thermal fuse, gas valve, igniter, thermostat.
Not Starting: Verify door switch, start switch, control board.
No Tumbling: Inspect drive belt, motor, idler pulley.
Overheating: Clean lint buildup, check thermostat, thermal fuse.
Error Codes: Refer to diagnostic chart in service manual.
Gas Ignition: Replace igniter if not glowing or cracked.
Belt Replacement: Remove front panel, install new belt.
Thermal Fuse: Test continuity; replace if open circuit.

WARNING! Disconnect power and gas before attempting repairs. Use genuine LG replacement parts.

Safety Features

Thermal Fuse: Cuts power if overheating detected. Door Switch: Stops operation when door opens. Gas Valve Safety: Automatic shut-off if ignition fails. Child Lock: Prevents accidental operation.

Care & Cleaning

Disconnect power before cleaning. Use mild detergent and soft cloth for exterior. Clean lint filter after every use. Vacuum lint from interior and exhaust periodically.

CAUTION! Do not use abrasive cleaners or solvents. Keep control panel dry.

Regulatory Information

UL Listed: Complies with UL safety standards. ANSI Z21.5.1: Gas clothes dryer safety standard. Energy Star: Meets energy efficiency guidelines. For support, visit www.lg.com or contact 1-800-243-0000.

Troubleshooting

Symptom	Possible Cause	Corrective Action
No heat	Thermal fuse, igniter, gas valve	Check thermal fuse continuity; replace igniter if not glowing; test gas valve operation.
Not starting	Door switch, power, control board	Verify door closes completely; check power supply; test control board functions.
Long drying times	Lint buildup, exhaust restriction	Clean lint filter; inspect and clean exhaust duct; check moisture sensor.
Unusual noise	Worn rollers, blower wheel, belt	Inspect drum rollers; check blower wheel for obstructions; examine drive belt.
Gas odor	Gas leak, improper combustion	Immediately turn off gas; check connections with soap solution; verify proper ventilation.

Reset: Unplug for 5 minutes to reset control board.

Service: 1-800-243-0000; www.lg.com