The LG Dryer DLG5988S is an electric dryer with 7.4 cubic feet capacity, featuring multiple drying cycles, moisture sensor technology, steam refresh option, LED display, and energy-efficient operation. This repair manual covers safety precautions, troubleshooting, disassembly procedures, component testing, and maintenance guidelines for qualified technicians.
Before attempting any repairs, ensure proper safety measures are followed.
| Hazard | Precaution |
|---|---|
| Electrical Shock | Disconnect power before servicing; verify with voltage tester |
| Fire Hazard | Clean lint filter after each use; inspect venting system |
| Moving Parts | Ensure dryer is completely stopped before disassembly |
| Hot Surfaces | Allow dryer to cool completely before handling components |
| Chemical Exposure | Wear gloves when handling cleaning solvents |
Essential tools for DLG5988S repair and maintenance.
WARNING! Use proper tools to avoid damage to components and ensure personal safety.
| Symptom | Possible Cause | Diagnostic Procedure |
|---|---|---|
| No power | Power supply, door switch, thermal fuse | Check outlet voltage; test door switch continuity; verify thermal fuse |
| No heat | Heating element, thermostat, thermal fuse | Test heating element resistance; check thermostat operation |
| Not tumbling | Drive belt, motor, idler pulley | Inspect belt condition; test motor windings; check idler pulley |
| Excessive noise | Rollers, glides, blower wheel | Inspect rollers for wear; check blower wheel balance |
| Error codes displayed | Sensor failure, control board | Reference error code chart; test sensors |
Step-by-step disassembly for component access.
CAUTION! Label all wires and take photos during disassembly for proper reassembly.
Testing procedures for major components.
| Component | Test Procedure | Expected Values |
|---|---|---|
| Heating Element | Measure resistance between terminals | 10-50 ohms (varies by model) |
| Thermal Fuse | Continuity test | Continuity (0 ohms) |
| Motor | Test windings resistance | 1-5 ohms between run windings |
| Door Switch | Continuity test with door open/closed | Open circuit when door open |
| Moisture Sensor | Resistance measurement | Varies with moisture level |
Common replacement parts for DLG5988S.
Reverse disassembly procedure with important notes.
Tip: Perform continuity tests after reassembly before applying power.
Recommended maintenance intervals.
| Maintenance Task | Frequency |
|---|---|
| Clean lint filter | After every load |
| Inspect venting system | Every 6 months |
| Clean moisture sensors | Every 12 months |
| Inspect drum rollers | Every 24 months |
| Check electrical connections | Every 36 months |
Common error codes and their meanings.
| Error Code | Description | Solution |
|---|---|---|
| dE | Door not closed properly | Check door latch and switch |
| tE | Thermal sensor error | Test thermal sensors and wiring |
| LE | Motor failure | Test motor and control board |
| FE | Moisture sensor error | Clean moisture sensor bars |
| OE | Overheating | Check venting and thermal fuse |
LG DLG5988S warranty coverage and service information.
Note: Warranty may be void if unauthorized repairs are performed.