LG Dryer DLE2101W Repair Manual

The LG Dryer DLE2101W is an electric dryer with 7.4 cu. ft. capacity, featuring multiple drying cycles, moisture sensor technology, stainless steel drum, reversible door, end-of-cycle signal, and ENERGY STAR certification. Below are key sections for safety, features, installation, operation, maintenance, troubleshooting, and repair procedures.

1. Features at a Glance 2. Installation Requirements 3. Operation Instructions 4. Technical Specifications 5. Controls and Settings 6. Maintenance Procedures 7. Common Repairs 8. Safety Features 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting Guide

Features at a Glance

Key components: Stainless steel drum, electronic controls, moisture sensor, lint filter, heating element, motor, and thermal fuse.

FeatureDescription
Capacity7.4 cubic feet stainless steel drum
Moisture SensorAutomatically detects dryness level
Drying Cycles10 cycles including Normal, Heavy Duty, Delicates
Temperature SettingsHigh, Medium, Low, No Heat
Reversible DoorCan be mounted to open left or right
End-of-Cycle SignalAudible alert when cycle completes
ENERGY STARCertified for energy efficiency
Lint FilterEasy-clean front access filter
Wrinkle CareTumbling without heat after cycle ends
Child LockPrevents accidental setting changes

Installation Requirements

Proper installation is critical for safe operation and performance.

  1. Location: Level, solid floor with minimum clearances (1" sides, 4" rear)
  2. Electrical: 240V, 30-amp dedicated circuit with proper grounding
  3. Venting: 4-inch diameter metal duct, maximum 64 feet equivalent length
  4. Gas connection: N/A (electric model only)
  5. Final check: Ensure drum rotates freely and door closes properly

WARNING! Installation must comply with local codes. Use only metal venting materials.

Operation Instructions

Power on dryer; select desired settings.

  1. Load clothing: Do not overload; leave space for tumbling
  2. Select cycle: Choose appropriate cycle for fabric type
  3. Set temperature: Select heat level based on fabric care labels
  4. Start dryer: Close door and press START
  5. Monitor: Moisture sensor will automatically adjust drying time

CAUTION! Clean lint filter before every load to prevent fire hazard.

Technical Specifications

Controls and Settings

Control panel includes cycle selector, temperature buttons, and start control.

Cycles: Normal, Heavy Duty, Permanent Press, Delicates, Quick Dry, Air Fluff, Sanitize, Bedding, Towels, Timed Dry

Temperatures: High, Medium, Low, No Heat (Air Fluff)

Options: Wrinkle Care, Signal Volume, Child Lock

Display: Shows remaining time, cycle status, and error codes

Maintenance Procedures

Regular maintenance ensures optimal performance and longevity.

  1. Clean lint filter after every load
  2. Monthly: Vacuum lint from interior and exhaust duct
  3. Quarterly: Inspect and clean exhaust vent system
  4. Annually: Check drum rollers and belt for wear
  5. As needed: Clean control panel with damp cloth

Tip: Keep area around dryer clear of lint and combustible materials.

Common Repairs

Common service procedures for DIY repair.

  1. Belt replacement: Access through front panel, route new belt properly
  2. Heating element: Test for continuity, replace if open circuit
  3. Thermal fuse: Located on blower housing, test for continuity
  4. Motor: Check for proper voltage and rotation
  5. Rollers and idler: Inspect for wear, replace if noisy
  6. Door switch: Test for proper operation when door closed

WARNING! Disconnect power before attempting any repairs.

Safety Features

Multiple safety systems protect against hazards.

Care & Cleaning

Unplug before cleaning. Use mild detergent and soft cloth only.

Exterior: Wipe with damp cloth, dry immediately

Interior: Clean drum with non-abrasive cleaner

Lint system: Remove all lint from filter housing and exhaust path

CAUTION! Do not use abrasive cleaners or solvents on any surfaces.

Regulatory Information

UL listed and certified to UL 2158. Complies with FCC Part 15. ENERGY STAR partner. Copyright © 2025 LG Electronics. For support, visit www.lg.com or contact 1-800-243-0000. Model DLE2101W manufactured for residential use only.

Troubleshooting Guide

SymptomPossible CauseCorrective Action
Dryer won't startPower, door switch, thermal fuseCheck power supply; test door switch; verify thermal fuse continuity
No heatHeating element, thermal fuse, thermostatTest heating element for continuity; check thermal fuse and thermostats
Drum not turningBelt, motor, idler pulleyInspect belt for breakage; check motor operation; replace idler if worn
Long drying timesLint restriction, venting, heating elementClean lint filter and exhaust system; check heating element performance
Error codes displayedSensor faults, system errorsRefer to error code chart in service manual; reset unit if needed

Reset: Unplug for 5 minutes to reset electronic controls.

Service: 1-800-243-0000; www.lg.com

LG Dryer DLE2101W Repair Manual © - All Rights Reserved 2025